Artemide Floor Lamp
Artemide Floor LampA brass stem rises from a thin circular base and angles up to hold a frosted glass globe about the size of a grapefruit. The stem is brushed brass—not shiny, just warm metal that reads honest. The globe glows soft and even, casting light that spreads wide without glare. It's minimal enough to disappear into a room corner or beside a sofa, but present enough that you notice the craft in how the globe sits on the arm. In the Room https://www.youtube.com/watch?v=37sBx_Ysl64 Specifications MaterialIron, glassLight SourceLED bulb or Edison bulbBulb BaseG9PowerMax 5WVoltageAC 110–240VFinishGoldGlassWhite frostedCable150 cm (59″) with switch plug; extendable upon requestHeight65″ (165 cm)Globe Diameter7″ (18 cm)Base Diameter10″ (25 cm) Dimensions Size: Dia 40cm x H 165cm / ∅ 15.7″ x H 64.9″ (Dimensions as shown) Where It Works This lamp works best in a living room, bedroom, reading corner, entryway, or home office—anywhere you need calm light that doesn't spread across the whole room. Documentation SpecificationsInstallation Guide3D Files Common Questions How stable is this on a hard floor or carpet?The base is about 10″ across and weighted to stay put on both hard floors and carpet. It won't tip if you bump it. On carpet, the feet may sink slightly over time, so check it every few months. Does it need assembly, and how long does it take?The globe screws onto the brass arm—takes two minutes. The stem arrives in one piece. Set it on the base, plug it in, and you're done. No tools needed. What kind of bulb goes in, and does it get hot?See the Specifications for bulb details. The frosted globe gets warm but not hot to touch when on. Give it a few minutes to cool before moving it. Where should I position this lamp in a room?It works best beside a sofa, in a reading corner, or next to a bed—anywhere you need calm light that doesn't spread across the whole room. The sphere height puts light at head level when you're seated. How do I clean the frosted glass without streaking it?Use a soft, dry microfiber cloth or a slightly damp cotton cloth and let it air-dry. Avoid glass cleaners—they leave marks on frosted finishes. Dust the brass with a dry cloth; it develops a natural patina over time.
